Garage Door Garage Door Sensor Installation Franklin, MI
Photo-eye safety sensor installation, alignment, and replacement. Required by UL-325 safety code — we test auto-reverse and verify the door stops on a 1.5-inch obstruction.
Garage Door Sensor Installation is one part of our garage door opener coverage in Franklin, MI. For the full picture — symptoms, costs, and when to repair vs. replace — start with the complete Garage Door Opener Repair guide, or browse every garage door opener service we offer.
Garage Door Garage Door Sensor Installation Franklin, MI
For garage door sensor installation around Franklin, the details that matter are local: winter snow and ice load on doors and tracks, humid summers that seize hinges and rollers, and spring damp that rusts unsealed cables and brackets. Our crews stock corrosion-resistant parts built for exactly those conditions.
Weather matters more than most Franklin homeowners expect. Local conditions — four distinct seasons of muggy summers and freezing, snowy winters, with wide annual temperature extremes — drive winter snow and ice load on doors and tracks, humid summers that seize hinges and rollers, and spring damp that rusts unsealed cables and brackets, so we recommend hardware and seals suited to Michigan's continental-climate region.
Across Oakland County, the garage door problems we see again and again are freeze-thaw-cracked bottom seals, cold-snapped torsion springs in deep winter, rusted hardware from snowmelt and road salt, and loosened hardware from wide seasonal swings. If that sounds like your door, there's a good chance we can fix it today.
Photo-eye safety sensors are required by UL-325 on every garage door opener manufactured since 1993. They detect obstructions in the door's path and either reverse the door (during close) or refuse to start (when activated). When sensors are misaligned, dirty, sun-blinded, or failed, the door either refuses to close at all or — worse — closes without sensing an obstruction. Our sensor installation service replaces failed sensors, realigns drifted brackets, cleans the eye optics, and verifies auto-reverse on a real obstruction test.
Replacement eyes are brand-specific (LiftMaster has a different connector and signal pattern than Genie). We stock the major brands and most legacy models. Brackets occasionally need replacement when corrosion has degraded them or impact has bent them. Bracket alignment is critical — eyes that are slightly off-aim trigger intermittent close failures that drive homeowners crazy.
Every visit ends with an obstruction test: a 1.5-inch (3.8 cm) tall object placed under the door at three positions across the opening. The door must reverse when it touches the object. This is the UL-325 baseline — if the door doesn't pass, the install isn't complete. We document the test results on the work order.
Photo-eye electronics fail at 10–15 years. Replacement is inexpensive and quick.
Our process
1
Call or schedule online. Line up garage door sensor installation for Franklin on a 2-hour window. We answer fast and send a confirmation — tech name, tech photo — inside five minutes.
2
On-site diagnosis. The garage door sensor installation diagnosis happens at your door: free for most repairs, a $39 fee on minor service calls that's waived the moment you approve the work. Nothing begins until you've seen it.
3
Flat-rate quote. You get a flat-rate garage door sensor installation quote in writing before any work begins — no hourly creep, no upsell pressure, because our techs are salaried, not commissioned.
4
Same-visit fix. Same-visit completion is the norm for garage door sensor installation: 96% of calls are fixed first time. We run the door with you to verify, then tidy up everything we touched.
How much does garage door sensor installation cost in Franklin, MI?
Garage Door Sensor Installation in Franklin starts at $99, quoted as a flat rate in writing before any work begins — no hourly creep and no surprise add-ons. The estimate is good for 30 days, so you can compare it on your own timeline. We keep garage door sensor installation affordable across Franklin, MI — one flat number quoted up front, the same one you pay at the end.
Garage Door Sensor Installation the United States starts at from $99, with Franklin garage door sensor installation priced flat-rate and written out before work starts — what you approve is what you pay, with no add-ons. Seniors (65+) and military save 10% on labor, and Synchrony financing runs 0% APR for 12 months on jobs over $1,500, no prepayment penalty.
Why homeowners in Franklin, MI choose us for garage door sensor installation
Garage Door Sensor Installation in Franklin should be simple — show up on time, quote before working, fix it once. That's how we've run since 1974 across Michigan's continental-climate region, with a 96% first-call fix rate. We're the garage door sensor installation company Franklin calls first — CSLB-licensed, insured, and based right here in Oakland County.
Every garage door sensor installation is guaranteed: a 10-year workmanship warranty, held separate from the manufacturer's coverage on the parts. Should our garage door sensor installation fail because of the install, we return and correct it at no charge for ten full years. 30,000-cycle springs are warrantied for the life of the original homeowner; other parts and accessories carry standard 1–5 year terms.
We keep garage door sensor installation honest two ways — honest sizing and honest scope. There's no up-sell because the techs are salaried, not commissioned, and the diagnostic shows you precisely what we see, parts in good shape included. Repair or replace, we recommend whichever wins long-term, and the garage door sensor installation quote is flat-rate, written, and valid 30 days.
Areas we serve for garage door sensor installation
We provide garage door sensor installation throughout Franklin, MI and the surrounding Oakland County area. Serving Coventry and surrounding neighborhoods.
Need more than garage door sensor installation? Our Franklin, MI garage door company page is the local hub for every repair, install, and opener job we handle across Franklin — start there for the full service lineup.
A note on the area for garage door sensor installation: Oakland County sits in Michigan. Our Franklin crews work that whole footprint daily, out to Bingham Farms, Beverly Hills, Southfield, and Lathrup Village.
Whether you're in Franklin or nearby Bingham Farms, Beverly Hills, Southfield, and Lathrup Village, our garage door sensor installation dispatch routes the closest stocked truck — that's the 90-minute average across Oakland County. We handle garage door sensor installation around 48025 and the rest of Franklin, MI on one daily route.
Garage Door Sensor Installation near you in Franklin, MI
Garage door sensor installation near you in Franklin means a crew staged within Oakland County, not dispatched from across the region. We keep response times short across Coventry and the surrounding Franklin area because we're already there.
Franklin is part of our greater Detroit, MI metro service area.
ZIP codes 48025 and their surroundings are covered for garage door sensor installation. Travel time for garage door sensor installation tracks Franklin traffic and time of day, so the accurate ETA comes when you phone in. Calls route directly to an on-call technician — no phone tree, no voicemail. "Local garage door sensor installation near me" in Franklin should mean a tech who already works your street — with us it does.
Frequently asked about garage door sensor installation
Top questions homeowners searching for Garage Door Sensor Installation near me ask us:
Which Franklin neighborhoods and ZIP codes do you serve?
We cover Coventry and the surrounding Franklin area — including ZIPs 48025. If you are anywhere in Franklin, you are in our service area — call (213) 221-2882 and we will confirm the next available window.
How does the climate in Franklin, MI affect my garage door?
Local weather drives most of the repairs we run in Franklin: with four distinct seasons of muggy summers and freezing and winter snow and ice load on doors and tracks, humid summers that seize hinges and rollers, and spring damp that rusts unsealed cables and brackets, the common failure modes are freeze-thaw-cracked bottom seals, cold-snapped torsion springs in deep winter, rusted hardware from snowmelt and road salt, and loosened hardware from wide seasonal swings. Our Franklin trucks stock the parts those conditions wear out first, so most jobs are a single visit.
Will new sensors work with my old opener?
Same-brand same-generation: yes. Different generation: sometimes, depends on the model. Different brand: rarely. We match generation when ordering.
How long does sensor work take?
Realignment: 15–30 minutes. Sensor replacement: 30–60 minutes. Full retrofit on an older opener: 60–90 minutes.
What's the coverage?
1-year manufacturer coverage on replacement sensors; 10-year workmanship on the install.
Are photo-eyes required by law?
UL-325 has required them on residential openers since 1993. UL-325 is the governing federal safety standard. Older openers without photo-eyes are non-compliant when replaced.